IAI America RCP2W-RA10C - Manual (Page 45)

39
5. Installation
5. Installation
5.1 Installing the Main Body
(1) Using tapped mounting holes at back
[A] Applicable models: RA2C, RA3C, RA3R, RGD3C types
The thread depths of mounting holes provided in the base of respective actuators are specified
below. Exercise caution to make sure the end of the bolt will not project from the thread.
Model Tapped hole size Effective thread depth
RA2C M3 5 mm
[B] Applicable models: RA10C
Tapped hole size
Effective thread
depth
M10 18 mm
Tapped mounting holes are
provided at the back of the
actuator. Install the actuator using
these tapped holes.
Tapped mounting holes are provided
at the back of the actuator. Install the
actuator using these tapped holes.
RA8C, RA8R
RA3C, RA3R, RGD3C
M8 16 mm
M4 6 mm