IAI America RCS-E - Manual (Page 10)

Pre-4
Notes on Safety of Our Products
Common items you should note when performing each task on any IAI robot are explained below.
No. Task Note
1 Model
selection
 This product is not planned or designed for uses requiring high degrees of safety.
Accordingly, it cannot be used to sustain or support life and must not be used in the
following applications:
[1] Medical devices relating to maintenance, management, etc., of life or health
[2] Mechanisms or mechanical devices (vehicles, railway facilities, aircraft facilities, etc.)
intended to move or transport people
[3] Important safety parts in mechanical devices (safety devices, etc.)
 Do not use this product in the following environments:
[1] Place subject to flammable gases, ignitable objects, flammables, explosives, etc.
[2] Place that may be exposed to radiation
[3] Place where the surrounding air temperature or relative humidity exceeds the
specified range
[4] Place subject to direct sunlight or radiated heat from large heat sources
[5] Place subject to sudden temperature shift and condensation
[6] Place subject to corrosive gases (sulfuric acid, hydrochloric acid, etc.)
[7] Place subject to excessive dust, salt or iron powder
[8] Place where the product receives direct vibration or impact
 Do not use this product outside the specified ranges. Doing so may significantly
shorten the life of the product or result in product failure or facility stoppage.
2 Transportation
 When transporting the product, exercise due caution not to bump or drop the product.
 Use appropriate means for transportation.
 Do not step on the package.
 Do not place on the package any heavy article that may deform the package.
 When using a crane of 1 ton or more in capacity, make sure the crane operators are
qualified to operate cranes and perform slinging work.
 When using a crane, etc., never hoist articles exceeding the rated load of the crane,
etc.
 Use hoisting equipment suitable for the article to be hoisted. Calculate the load
needed to cut off the hoisting equipment and other loads incidental to equipment
operation by considering a safety factor. Also check the hoisting equipment for
damage.
 Do not climb onto the article while it is being hoisted.
 Do not keep the article hoisted for an extended period of time.
 Do not stand under the hoisted article.
3 Storage/
preservation
 The storage/preservation environment should conform to the installation environment.
Among others, be careful not to cause condensation.
4 Installation/
startup
(1) Installing the robot, controller, etc.
 Be sure to firmly secure and affix the product (including its work part).
If the product tips over, drops, malfunctions, etc., damage or injury may result.
 Do not step on the product or place any article on top. The product may tip over or the
article may drop, resulting in injury, product damage, loss of/drop in product
performance, shorter life, etc.
 If the product is used in any of the following places, provide sufficient shielding
measures:
[1] Place subject to electrical noise
[2] Place subject to a strong electric or magnetic field
[3] Place where power lines or drive lines are wired nearby
[4] Place subject to splashed water, oil or chemicals