FlexLink XT (макс. 30 кг) Монтаж - Manual (Page 72)

72 5113235
7 If F=F02
Put the support frame in position below and
between the conveyor beams. Insert the four M8
slot nuts into the T-slot on the upper side of the
support frame beams.
CAUTION! The horizontal plane on the support
frame and the plane on the conveyor chains must
be parallel.
8 If F=F02
Mount the unit on top of the support frame and
tighten the four M8 screws using a 5 mm Allen
key.
9 Adjust the support, unit and/or the conveyor so
that the lift and locate device is positioned cor-
rectly.
10 To adjust the height of the module stroke. Place a
pallet on the top plate and press it up to the cor-
rect position. Fix the top plate in that position.