FlexLink XT (макс. 30 кг) Монтаж - Manual (Page 32)

32 5113235
3 Fit the connecting plate and tighten the screws.
Use the 5 mm allen key.
4 Turn up the motor. Fit and tighten the screw for
torque arm. Use the 13 mm box wrench.
CAUTION! Make sure that the torque arm fork
has entered the cage in a correct way. An
unlocked rotating motor can cause personal
injury.
5 Fit the remaining connecting plates. Place the
roller bridge between the conveyors.
CAUTION! Fit one connecting plate at a time to
ensure the unit remains intact, never loosen
screws for more than one connecting plate at a
time.
6 Use a ruler to make sure that the roller bridge is
in the correct vertical position. Max distance
between ruler and roller: 1 mm.
If needed, loosen the screws for the connecting
plates again and adjust until the necessary
space is obtained.