FlexLink XB Монтаж - Manual

Information from FlexLink No. 98-01-03
XB conveyor beam
Assembly instructions
The following tools are required:
• Mounting tool for aluminium clip – 3923518
• Allen key – 4 mm
• Measuring tape
• Set-square
• Idler end unit – XBEJ A175
The following components are required:
• Beam (mid-section) – XBCB 3A85
• Beam (outer section) – XBCB 3A H
• Aluminium clips – XBCE 40
(for correct number, see table below)
Number of pieces
Beam length
(mm) XBCB 3A85 XBCB 3A H XCBE 40
(pairs)
500–1000 1 1 4
1001–1500 1 1 6
1501–2000 1 2 8
2001–2500 1 2 10
2501–3000 1 2 12
XBCB 3A H
XBCB 3A85
XBCE 40
XBCB 3A H
XBCB 3A85
XBCE 40
XBCB 3A H
XBCB 3A85
XBCE 40