FlexLink Направляющие и салазки (сталь) Монтаж User Manual
B. installation of slide rail in hardened steel

B. Installation of slide rail in hardened steel
467
PO
X45
XS
XL
XLP
X85
X85P
XH
XK
XKP
X180
X300
GR
CS
XT
XC
XF
XD
FST
XLX
X85X
X180X
X300X
GRX
CSX
ELV
CTL
TR
APX
IDX
B. Installation of slide rail in hardened steel
Installation of hardened steel slide rail – XK
Tools required
Mounting at drive unit/idler ends
Mounting in straight sections
Mounting at wheel bends
Locking pliers
Knife
Drill
Drill bit
∅
4,2 mm
Angle grinder
Slide rail fixture
5056186 (see picture)
Hydraulic pump for riveting
See picture
Rivets
5056167
Hydraulic pump for riveting
Slide rail fixtures
1 Cut off the flanges on the
plastic guides.
2 Cut the slide rail. If neces-
sary, drill a hole in the
slide rail (See step 9).
3 Drill through the alumin-
ium beam with a 4,2 mm
drill bit.
4 Place a rivet in the hole
and fasten (See step 12).
5 Polish all sharp edges.
6 Place the slide rail on the
beam. Mark the beam
edge on the slide rail, add
50 mm and cut.
7 Cut the slide rail at an
angle.
8 Round off the corner and
polish all sharp edges.
9 If necessary, drill and
countersink a new hole
40 mm from the edge.
10 Place the slide rail at the
correct distance by using
the fixtures. Fix the slide
rail with locking pliers.
Drill through the alumin-
ium beam with a 4,2 mm
drill bit.
11 Place the bend slide
rail/rails on the wheel
bend. Make sure the dis-
tance to the disc is 51–
53 mm. Fix the slide rail
with locking pliers. Drill
through the aluminium
beam.
12 Place the rivet in the hole,
make sure the plunger
hits the whole rivet and
press. Note. Use maxi-
mum pressure of 200 bar.
13 Grind down the rivets with
a grinding wheel until you
have a smooth surface.