Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 87)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Matrix Software 81
Ties as Lines — Displays ties as lines (below).
Ties as Crosspoints — Displays ties as a matrix of inputs and outputs (see figure 51). Ties
that have been made are indicated as amber or green boxes. Ties that will take effect when
you click
Take are indicated by + . Ties that will be broken when you click Take are indicated
by – .
Figure 51. Ties Shown as Crosspoints
Signal-detection options — Allows you to set the signal presence feature as follows, to:
• Automatically refresh the display every 10 seconds.
• Update the display whenever you refresh the screen.
• Never sample and display the link status.
Icons in I/O Boxes — Erases any numbers in the I/O boxes in the Control
Program window (see figure 37 , on page 66). You can place icons in the boxes.
Numbers in I/O Boxes — Erases any icons in the I/O boxes in the Control
Program window and fills each box with the associated input or output number.
Catch FPC/other’s changes — When checked, sets the switcher to report all
configuration and setting changes to the serial port or Ethernet connection that turned this
selection on. These reports allow the Matrix Switchers Control Program to track the changes
that occur in the configuration and settings of the switcher, whether commanded via the
front panel, either serial port, or the Ethernet port.
Master-Reset selection
Master reset performs all of the following functions:
• Clears all ties
• Clears all presets
• Clears all output mutes
• Resets all I/O grouping
NOTE: Master reset does not reset the Internet protocol (IP) settings.