Eating a tie, Creating ties, sets of ties, and configurations – Extron Electronics DMS 1600_2000_3200_3600 User Guide User Manual
Page 29
DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Operation
23
Example 1: Creating a set of ties
In the following example, input 5 is tied to outputs 3, 4, and 8. The steps show the front
panel indications that result from your action.
NOTE: This example assumes that there are no ties in the current configuration.
1.
Clear all selections: Press and release the Esc button. The button flashes once.
2.
Select an input: Press and release the input 5 button.
1
2
3
4
5
6
7
8 15 16
INPUTS
Press the button.
The button lights.
3.
Select the outputs: Press and release the output 3, output 4, and output 8 buttons.
C O N T R O L
PRESET
ENTER
ESC
VIEW
1
2
3
4
5
6
7
8 15 16
OUTPUTS
1
Press and release the buttons.
The buttons blink to indicate that the selected input will be tied
to these outputs.
The Enter button blinks
to indicate the need to
confirm the change.
NOTE: You can cancel the entire set of ties at this point by pressing and releasing
the Esc button. The Esc button flashes once and all selected input and output
buttons return to unlit or background illumination.
4.
Confirm the change: Press and release the Enter button.
ENTER
All input buttons and output buttons
return to unlit or background illumination.
Press the button.
The Enter button returns to
unlit or background
illumination.
The current configuration is now input 5 tied to output 3, output 4, and output 8 (see
figure 18).
Input 5 tied
to outputs 3, 4, and 8
Input
Output
3
4
8
5
Figure 18.
Example 1: Create Ties