Serial-port or usb-port-connected firmware upload – Extron Electronics DMS 1600_2000_3200_3600 User Guide User Manual
Page 81
DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Matrix Software
75
Serial-port- or USB-port-connected firmware upload
1
Figure 44.
Extron Firmware Loader Window
11.
Select the DMS matrix switcher and click
File
>
Open
(see figure 44 [
a
]).
The Choose File to Upload dialog box opens (see figure 45).
2
2
Figure 45.
Choose File to Upload Dialog Box
12.
Navigate to and select the new firmware file. Click
Open
(
b
). The Choose File to Upload
dialog box closes.
ATTENTION: The firmware file must have an .s19 extension. Other file types can
cause the switcher to stop functioning until a reset is performed.
13.
In the Firmware Loader window, click
Begin
(see figure 46).
The Total Progress and Progress status bars show the progress of the upload, which
may take several minutes. Once the status bars have progressed from
0%
to
100%
, and
Status is listed as
Complete
, the firmware loader utility resets the switcher.
Figure 46.
Firmware Loader Screen
14.
Click
Exit
to close the Firmware Loader.