Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 107)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Maintenance and Modifications 101
Removing and Installing the I/O Board or Blank Panel
NOTE: For proper cooling and air flow, install boards or blank panels in all locations.
Figure 67 shows a mix of I/O boards. On the boards, the input and output DVI connectors
are identified as A through D. Each I/O board is identified by the input and output numbers
supported by the board position (1 - 4, 5 - 8, and so on).
ANAHEIM, CA
100-240V 50/60Hz 1.2A MAX. PRIMARY POWER SUPPLY REDUNDANT POWER SUPPLY
1 - 4
5 - 8
9 - 12
13 - 16
A B
DVI-D INPUTS DVI-D OUTPUTS
C D A B C D
DVI-D OUTPUTS
A B C D
A B
TMDS
FIBER
INPUTS
C D A B
TMDS
FIBER
OUTPUTS DMS FIBER 44
C D
Location A
Input
Location D
Output
Location D
Output
Location A
Input
Input 1
Slot 1
(1-4) Input/Output
Board
Slot 2
(5-8) Input/Output
Board
Slot 4
No board installed
Slot 3
(9-12) Output Board
Input 2 Input 3 Input 4
Input 5 Input 6 Input 7 Input 8
Output 9
Output 10
Output 11
Output 12
Output 1 Output 2 Output 3 Output 4
Figure 67. Arrangement of Inputs and Outputs on the I/O Boards
Slot Inputs and outputs Slot Inputs and outputs
1 1 through 4 5* 17 through 20
2 5 through 8 6  21 through 24
3 9 through 12 7  25 through 28
4 13 through 16 8  29 through 32
9  33 through 36
* DMS 2000, DMS 3200, and DMS 3600 only
 DMS 3200 and DMS 3600 only
 DMS 3600 only
Locations A through D correspond to the input and output numbers identified by the board
position numbers. (For example, the input and output numbers supported by the I/O board
in slot 2 (location 5 - 8) are as follows: A = 5, B = 6, C = 7, and D = 8.) Inputs and outputs
are grouped separately, with inputs A through D on the left and outputs A through D on the
right.
Below are installation guidelines for the switcher configuration; if you incorrectly order the
I/O boards, the switcher will not recognize some inputs, outputs, or both.
• You must install a 4x4 DVI or fiber optic input and output board in the top slot (slot 1).
• You can install any of the six board types (a 4x4 DVI or fiber optic input and output
board, a 4 DVI or fiber optic input board, or a 4 DVI or fiber optic output board) or a
blank panel in the next slot (slot 2).
• You can install any of the board types in the slot directly underneath a 4x4 input and
output board.
• After you install a 4-input board or 4-output board, all active boards underneath it must
be the same size (4-input or 4-output).
• Within these size guidelines (4-input must follow 4-input or 4-output must follow
4-output), you can follow a DVI board with a fiber optic board or follow a fiber optic
board with a DVI board.
• If you install a blank panel, all slots under it must contain blank panels (you cannot skip
a slot).