Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 35)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Operation 29
Example 5: Grouping inputs and outputs
In the following example, several switcher inputs and outputs are assigned to groups. The
steps show the front panel indications that result from your action.
1. Clear all selections: Press and release the Esc button. The button flashes once.
2. Select I/O Group mode: Press and hold the Input 1 and Output 1 buttons
simultaneously for approximately 2 seconds and then release the buttons.
1
1
1 2 3
1 2 3
Press and hold the Input 1 button and Output 1 button.
Release the Input 1 button
and Output 1 button.
Ungrouped input and
output buttons light.
2 seconds
3. Select an I/O group: Press and release the Enter button to select group 1.
C O N T R O L
PRESET ENTER ESC VIEW
Press the button. The button lights.
1 3 2 4 Group #
4. Assign inputs and outputs:
a. One at a time, press and release the input 1 through 4 buttons.
1 2 3 4 5 6 7 8 15 16
INPUTS
Press the buttons. The selected buttons light.
b. One at a time, press and release the output 1 through 4 buttons.
1 2 3 4 5 6 7 8 15 16
OUTPUTS
Press the buttons. The selected buttons light.
5. Select an I/O group: Press and release the Preset button to select group 2.
C O N T R O L
PRESET ENTER ESC VIEW
1 3 2 4 Group #
Press the button. The button lights.