Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 7)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Introduction 1
Introduction
WARNING: Risk of serious physical injury — The DMS fiber optic I/O boards output
continuous invisible light, which may be harmful to the eyes; use with caution.
• Do not look into the fiber optic cable connectors or into the fiber optic cables
themselves.
• Plug the attached dust caps into the optical transceivers when the fiber cable is
unplugged.
• About this Guide
• About the DMS Matrix Switchers
• Features
About this Guide
This guide contains installation, configuration, and operating information for the Extron
DMS 1600, DMS 2000, DMS 3200, and DMS 3600 Matrix Switchers (see
figure 1 on the
next page). These customizable matrix switchers support DVI inputs and outputs and the
fiber optic outputs and inputs of Extron DFX transmitters and receivers. The switchers can
support multiple inputs and outputs, depending on the model:
• DMS 1600 — up to 16 inputs and outputs
• DMS 2000 — up to 20 inputs and outputs
• DMS 3200 — up to 32 inputs and outputs
• DMS 3600 — up to 36 inputs and outputs
NOTE: In this guide, “DMS matrix switcher” refers to any switcher model.
About the DMS Matrix Switchers
The DMS matrix switchers are configurable, modular matrix switchers that distribute a single
link of DVI (or HDMI with suitable adapters) digital video and DFX transmitter and receiver
outputs and inputs. The switchers are assembled from user-installed input and output (I/O)
boards. There are six I/O boards available:
• 4-input x 4-output DVI board • 4-input x 4-output mutimode fiber optic board
• 4-input DVI board • 4-input multimode fiber optic board
• 4-output DVI board • 4-output multimode fiber optic board