Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 15)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Installation 9
ATTENTION: Use electrostatic discharge (ESD) precautions (be electrically grounded)
when making connections. Electrostatic discharge can damage equipment, even if
you cannot feel, see, or hear it.
Remove system power before making all connections.
I/O Boards
I/O board configuration overview
Figure 7 shows a mix of I/O boards. On the boards, the input and output DVI connectors
are identified as A through D. Each I/O board is identified by the input and output numbers
supported by the board position (1 - 4, 5 - 8, and so on).
ANAHEIM, CA
100-240V 50/60Hz 1.2A MAX. PRIMARY POWER SUPPLY REDUNDANT POWER SUPPLY
1 - 4
5 - 8
9 - 12
13 - 16
A B
DVI-D INPUTS DVI-D OUTPUTS
C D A B C D
DVI-D OUTPUTS
A B C D
A B
TMDS
FIBER
INPUTS
C D A B
TMDS
FIBER
OUTPUTS DMS FIBER 44
C D
Location A
Input
Location D
Output
Location D
Output
Location A
Input
Input 1
Slot 1
(1-4) Input/Output
Board
Slot 2
(5-8) Input/Output
Board
Slot 4
No board installed
Slot 3
(9-12) Output Board
Input 2 Input 3 Input 4
Input 5 Input 6 Input 7 Input 8
Output 9
Output 10
Output 11
Output 12
Output 1 Output 2 Output 3 Output 4
Figure 7. Arrangement of Inputs and Outputs on the I/O Boards
Slot Inputs and outputs Slot Inputs and outputs
1 1 through 4 5* 17 through 20
2 5 through 8 6  21 through 24
3 9 through 12 7  25 through 28
4 13 through 16 8  29 through 32
9 
33 through 36
* DMS 2000, DMS 3200, and DMS 3600 only
 DMS 3200 and DMS 3600 only
 DMS 3600 only
Locations A through D correspond to the input and output numbers identified by the board
position numbers. (For example, the input and output numbers supported by the I/O board
in slot 2 [location 5 - 8] are as follows: A = 5, B = 6, C = 7, and D = 8.) Inputs and outputs
are grouped separately, with inputs A through D on the left and outputs A through D on the
right.