Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 56)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Programming Guide 50
Command and Response Table for SIS Commands
Symbol definitions for command and response table
] = CR/LF (carriage return/line feed)
} = Carriage return (no line feed)
| = Pipe (can be used interchangeably with the } character)
• = Space (hard) character
E = Escape key (hex 1B)
W = Can be used interchangeable with the E character
X! = Input number (for tie) 00 – 16, 20, 32, or 36 (the highest numbered input for your model) (00 = untied)
X@ = Output 01 – 16, 20, 32, or 36 (the highest numbered output for your model)
X# = Mute, front panel lock 0 = not muted/not locked, 1 = muted/locked
X$ = DDC value (EDID) (see the table on page 52 )
X% = Input number 01 – 16, 20, 32, or 36 (the highest numbered input for your model)
X^ = Global preset number 00 through 32 (00 = current configuration)
X& = Room number (for room presets) 01 through 10 (each can have up to 10 room presets [ X( s] assigned)
NOTE: A room is a subset of operator selected outputs that relate to each other. The DMS matrix switcher supports up to 10 rooms, each
of which can consist of from 1 to 16 outputs.
X* = Name Up to 12 characters for input and output names, global preset names, and room
preset names
11 characters maximum for room names
Upper-and lower-case alphanumeric characters are valid
NOTE: The following characters are invalid or not recommended in the name: ~ , @ = ‘ [ ] { } < > “ : | \ and ?.
X( = Room preset number 01 through 10
NOTE: A room preset is a stored configuration with all of the outputs assigned to a single room. When a room preset is recalled from
memory, it becomes the current configuration.
X1) = Connection status 0 = no input connected 1 = input connected
X1! = Group number (for I/O grouping) 1 through 4 (or 0 = no group)
X1@ = Number (quantity) of inputs 4, 8, 12, 16, 20, 24, 28, 32, 36
X1# = Number (quantity) of outputs 4, 8, 12, 16, 20, 24, 28, 32, 36
X1$ = Board installed X0 = No board installed
C1 = DVI 4 inputs x 4 outputs
D1 = Fiber 4 inputs x 4 outputs
C2 = DVI 4 inputs x 0 outputs D2 = Fiber 4 inputs x 0 outputs
C3 = DVI 0 inputs x 4 outputs D3 = Fiber 0 inputs x 4 outputs
X1% = Part number 60-nnnn-01
X1^ = Firmware version number to second decimal place (x.xx)
X1& = Verbose firmware version-description- See the Query controller firmware version (verbose) command on page 56
upload date/time
X1* = Voltage Positive or negative voltage and magnitude
X1( = Temperature Degrees Fahrenheit
X2) = Fan speed In revolutions per minute (RPM)
X2! = Power supply status 0 = not installed or failed 1 = installed and OK