Using presets, Presets – Extron Electronics DMS 1600_2000_3200_3600 User Guide User Manual

Page 36

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Operation

Assign inputs and outputs:

One at a time, press and release the input 5 through 8 buttons.

8 15 16

INPUTS

Press the buttons. The selected buttons light.

One at a time, press and release the output 5 through 8 buttons.

8 15 16

OUTPUTS

Press the buttons. The selected buttons light.

Do nothing for approximately 30 seconds. The switcher exits I/O Group mode.
In this example:

•

Group 1 consists of inputs 1 through 4 and outputs 1 through 4.

•

Group 2 consists of inputs 5 through 8 and outputs 5 through 8.

Using Presets

The current configuration (configuration 0) can be saved as a preset in any one of 32 preset
memory addresses. Presets can be saved and recalled from the front panel.

•

On the DMS 1600 and DMS 2000, the preset locations are assigned to both the input
and output buttons (see figure 22).

•

On the DMS 3200 and DMS 3600, the preset locations are assigned to input buttons 1
through 32.

Input
buttons

Output
buttons

DMS 1600

DMS 2000

Preset

INPUTS

9 10 11 12

14 15 16

9 10 11 12

14 15 16

OUTPUTS

1 2 3 4 5 6 7 8 9 10

11 12 13 14 15 16 17 18 19 20

1 2 3 4 5 6 7 8 9 10

11 12 13 14 15 16 17 18 19 20

Preset

Input
buttons

Output
buttons

Preset

Figure 22.

DMS 1600 and DMS 2000 Preset Locations

When a preset is retrieved from memory, it becomes the current configuration.