Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 67)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Matrix Software 61
Matrix Software
This section describes using software to operate the DMS matrix switchers, including:
• Matrix Switchers Control Program
• Button Label Generator Program
Matrix Switchers Control Program
The Extron Matrix Switchers Control Program communicates with the switcher via the
Ethernet LAN port, the serial port, or the USB port to provide an easy way to set up ties
and sets of ties. The program is compatible with Microsoft® Windows® 2000, Windows XP,
Windows 7, and newer operating systems. Updates to the Matrix Switchers Control
Program can be downloaded from the Extron website (
www.extron.com ).
Installing the Software
NOTE: To support the front panel Configuration (USB) port, you must use version 8.0 or
newer of the Matrix Switchers Control Program.
The program is available on the Extron Software Products disc. Install the software as follows:
NOTE: For full functionality, install both of the following programs:
• Matrix Switchers Control Program
• Firmware Loader
1. Insert the disc into the drive. The Extron software DVD window should open
automatically (see figure 31).
Figure 31. Software DVD Window
NOTE: If the window does not open automatically, run Launch.exe from the DVD.
2. Click the Software tab.
3. Scroll to the desired program and click Install (see figure 32).
Figure 32. Software Installation