Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 69)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Matrix Software 63
Using the Matrix Switcher Control Software
Many items found in the Matrix Switchers Control Program are also accessible via front
panel controls (see
Front Panel Operations on page 21) and under SIS control (see
Command and Response Table for SIS Commands ) on page 50). The Matrix Switcher
Help Program provides information on settings and on how to use the control program,
itself.
NOTE: The first time you connect to the Configuration (USB) port, the Found New
Hardware Wizard opens (see figure 33) (see “Activating a USB Port for the First Time,”
below).
For other connections, proceed to
Starting the program on the next page.
1
2
3
4
Figure 33. Found New Hardware Wizard
Activating a USB Port for the First Time
The first time you connect to the Configuration (USB) port, the Found New Hardware Wizard
opens (see figure 33). Activate the connected USB port for your device as follows:
NOTE: If you have not installed the latest Matrix Switchers Control Program (version 8.0
or newer), click Cancel and install the program. Reconnect the switcher to the
Configuration port.
1. Select No, not this time .
2. Click Next .
3. Select Install the software automatically .
4. Click Next .
5. Follow the on-screen instructions.
The wizard assigns the driver necessary to access the switcher to the connected
Configuration (USB) port. This may take a few minutes.
6. Click Finish to exit the wizard.
7. Proceed to Starting the program on the next page or return to Programming Guide
on page 46.
NOTE: You may need to repeat these steps if you subsequently connect the
switcher to a different USB port on the same computer.