Changing a configuration – Extron Electronics DMS 1600_2000_3200_3600 User Guide User Manual
Page 30
DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Operation
24
Example 2: Adding a tie to a set of ties
In the following example, a new tie is added to the current configuration. The steps show
the front panel indications that result from your action.
NOTE: This example assumes that you have performed
1.
Clear all selections: Press and release the Esc button. The button flashes once.
2.
Select an input: Press and release the input 5 button.
1
2
3
4
5
6
7
8 15 16
1
2
3
4
5
6
7
8 15 16
INPUTS
OUTPUTS
Press the button.
The button lights.
The Output 3, Output 4, and Output 8 buttons light
to indicate the ties created in example 1.
3.
Select the output: Press and release the output 1 button.
C O N T R O L
PRESET
ENTER
ESC
VIEW
1
2
3
4
5
6
7
8 15 16
OUTPUTS
The Enter button blinks
to indicate the need to
confirm the change.
Press the button.
The button blinks to indicate that the
selected input will be tied to this output.
4.
Confirm the change: Press and release the Enter button.
ENTER
All input buttons and output buttons
return to unlit or background illumination.
Press the button.
The Enter button returns to
unlit or background
illumination.
The current configuration is now input 5 tied to output 1, output 3, output 4, and output 8
(see figure 19).
Input 5 tied
to outputs 1, 3, 4, and 8
Input
Output
1
3
4
8
5
Figure 19.
Example 2: Add a Tie