Extron Electronics DMS 1600_2000_3200_3600 User Guide - Manual (Page 109)

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Maintenance and Modifications 103
Removing and Installing the Power Supply Module
(DMS 1600 and DMS 3600)
NOTES:
• The redundant power supply is an optional accessory for the DMS 1600.
The redundant power supply is standard for the DMS 3600.
• The power supply modules are hot-swappable. Either power supply can be
removed or installed without powering down the switcher.
The primary and redundant power supply modules are identical and hot-swappable. Each
power supply module has a 2-color LED, visible on the rear panel, that indicates the status
of the power supply outputs. If the LED is lit green, the power supply is operating normally. If
the LED is lit red, the supply has failed and should be replaced at the earliest opportunity.
ATTENTION: The DMS matrix switchers use double pole/neutral fusing. Power must
be disconnected before servicing internal components.
Removing the Power Supply Module
Remove a power supply module as follows:
1. Rotate the left and right knurled knobs to completely loosen the screws.
2. Gently pull on the handle to loosen the power supply from the backplane (see figure 69).
3. Slide the power supply out of the chassis.
ANAHEIM, CA
RESET
REMOTE RS-232/RS-422
LAN
BI-LEVEL
TRI-LEVEL
ACT LINK
PRIMAR
Y POWER SUPPL
Y
1 - 8
9 - 16
17 - 24
25 - 32
Align with plastic chassis guides.
Knurled
Knobs
A
B
DVI-D INPUTS
DVI-D OUTPUTS
DMS 44 DVI
C
D
A
B
C
D
A
B
DVI-D INPUTS
DVI-D OUTPUTS
DMS 44 DVI
C
D
A
B
C
D
A
B
DVI-D INPUTS
DVI-D OUTPUTS
DMS 44 DVI
C
D
A
B
C
D
A
B
DVI-D INPUTS
DVI-D OUTPUTS
DMS 44 DVI
C
D
A
B
C
D
100-240V 50/60Hz 1.2A MAX.
100-240V 50/60Hz 1.2A MAX.
REDUNDANT
PRIMAR Y
DISCONNECT BOTH POWE
R
CO RD S B EF OR E S ER VIC ING
Figure 69. Power Supply Replacement