Viewing a configuration, Viewing ties, sets of ties, and configurations – Extron Electronics DMS 1600_2000_3200_3600 User Guide User Manual
Page 32
DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Operation
26
Viewing a Configuration
The current configuration can be viewed using the front panel buttons. The View-only mode
prevents inadvertent changes to the current configuration. View-only mode also provides a
way to mute outputs (see
, on page 33).
View the current configuration as follows:
1.
Press the Esc button to clear any front panel button indications that may be lit.
2.
Press and release the View button. All of the buttons light for outputs that are not tied.
3.
Select the desired input or outputs whose ties you wish to view by pressing the input
and output buttons.
If you press an output button for which there are no ties, the output buttons light for all
outputs without ties.
NOTES:
•
To see all ties of the current configuration, press and release each input and
output button, one at a time.
•
After 30 seconds of front panel inactivity, View-only mode automatically ends.
Example 4: Viewing Ties
In the following example, the ties in the current configuration are viewed. The steps show
the front panel indications that result from your action.
NOTE: This example assumes that you have performed
, and
1.
Clear all selections: Press and release the Esc button. The button flashes once.
2.
Select View-only mode: Press and release the View button.
C O N T R O L
PRESET
ENTER
ESC
VIEW
1
2
3
4
5
6
7
8 15 16
OUTPUTS
Until you select an input, only the buttons for untied outputs light.
Press the button. It lights.
3.
Select an input: Press and release the input 5 button.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8 15 16
INPUTS
15 16
OUTPUTS
The output buttons for outputs that are not tied to
Input 5 are either unlit or background illuminated.
The output buttons for outputs
that are tied to input 5 light.
Press the button. It lights.