R&M Materials Handling WIRE ROPE HOISTS Service - Manual (Page 52)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
52/130
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
5.19.1 Service
5.19.1.1 Traveling motor
• Check that the traveling motor operates properly when loaded.
• Check for any excessive noise, vibration and/or heat.
• Clean the cooling-ribs surface when needed.
5.19.1.2 Traveling gearbox
• Check the gearbox visually for leakage.
• In case the gearbox shows signs of excessive leakage, find the reason for this and replace the worn
part, or the complete gearbox.
• Check the breather-plug (if applicable) breaths freely and clean if needed.
• Check for any excessive vibration and/or noise.
#
If the factory-installed grease is topped up with a different lubricant, ensure that the lubricant is
compatible. Refer to the section “Lubricants” for further instructions.
5.19.1.3 Traveling brake
• Remove the end-cap of the motor.
• Check the air gap of the brake.
!
If the air gap is greater than 0,2…0,3 mm, the brake disc may be worn out. Check the
thickness of the brake disc.
• Adjust the air gap when needed.
• Remove dust and dirt from the brake.
• Close the end-cap and check the proper functioning.