R&M Materials Handling WIRE ROPE HOISTS Service - Manual (Page 106)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
106/130
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
6.2 Low headroom trolley, drum size φ 243 mm
Clearance between the wheel flange and the main girder flange (measure X) must be 3…5 mm. Ensure
that the clearance is equal on both ends of the trolley.
c_qztr01c
5
1
4
2
3 6
1. Locking washers
2. Fixing nuts
3. Plain washers
4. Adjusting nuts
5. Lifting mounts
6. Screw rods
• Remove the temporary transport supports. Take the hoist out of the packing and move it to the
installation site. Lift the hoist using the lifting mounts (5).
!
Do not unscrew the fixing nuts on the hoisting machinery side!
• Lift the hoist onto the beam. Adjust the X measurement until there is a gap of approximately 3…5mm
between the flange of the travel wheels and the flange of the beam.
• Check the wheels of the trolley are correctly aligned.
!
Tighten the adjusting nuts (4) on both sides to the correct tightening torque. Refer to the
section “Recommended tightening torques”.