R&M Materials Handling WIRE ROPE HOISTS Service - Manual (Page 113)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
113/130
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
6.6 Normal headroom trolley, drum diameter 608 mm
6.6.1 Straight beam
L1
L3
L2
B
A
L4
6
c_nab3a
1. Adjusting bar for trolley position
2. Adjusting nuts for flange width
3. Trolley positioning nuts
4. Frame tube
5. Trolley side plate
6. Adjusting bar for flange width
• Remove the temporary transport supports. Take the hoist out of the packing and move it to the
installation site. Lift the hoist using the lifting points marked on the hoist.
• Loosen the adjusting nuts for flange width (2). Adjust the distance between the travel wheels (A) so
that it is slightly wider than the beam flange (B) for installation purposes.
• Lift the hoist onto the beam.
• Adjust the side plate (5) of the trolley inwards until there is no gap between the flange of the travel
wheels and the flange of the beam. Then adjust the other side plate (5) of the trolley inwards until
there is a gap of approximately 3…5mm between the flange of the travel wheels and the flange of the
beam.
• Loosen the adjusting nuts for trolley positioning (3).