beautypg.com

R&M Materials Handling WIRE ROPE HOISTS Service User Manual

Page 10

background image

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319

10/130

R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.

c_hopb1d

A. Markings in compliance with FEM and DIN standards
B. Markings in compliance with SEN standard
C. Markings in compliance with SFS standard
D. Markings in compliance with ANSI standard
1. Up/Down pushbutton
2. Right/Left pushbutton for trolley
3. Forwards/Backwards pushbutton for bridge of crane
4. Hoist selection pushbutton (only if the pushbutton controls several hoists)
5. On pushbutton and warning signal
6. Emergency stop pushbutton (released by turning, lockable in some models)

Use the following procedure to start up a hoist that is in standby mode:
• Release the emergency stop pushbutton (6) by turning it. Use a key to release if it is the lockable

type.

• Press the On pushbutton (5). The hoist is now ready for operation.

!

If the pushbutton controller includes a selection switch, check that the hoist selection
switch (4) is in the correct position before using pushbuttons (1), (2) and (3).

After operating the hoist, return it to standby mode as follows:
• Run the hoist to the correct parking position. Stop all hoist motions.

• When all hoist motions have ceased, press the emergency stop pushbutton (6). The pushbutton will

lock.