B&B Electronics ADAM-6066 - Manual - Manual (Page 75)

65 Chapter 5
6. Monitor Stream/ Adam5000 Event Data - ADAM-6000 modules
support Data Stream function. You can define the Host (such as a
PC) by IP. Then ADAM-6000 modules will periodically send its I/
O status to the Host. The IP and period to transfer data is config-
ured in the Stream tab of Status Display area. The configuration
tab will be introduced in Section 5.3.2.
7. Monitor Peer-to-Peer (Event Trigger) - ADAM-6000 modules with
Peer-to-Peer function can play as Event Trigger function. Refer to
Section 5.3.4 for more information. You can choose this option to
receive message from ADAM-6000 module which is enabled Peer-
to-Peer (Event Trigger) function.
8. Monitor GCL IO Data Message - ADAM-6000 modules with GCL
function can play as a standalone controller. Users can define logic
rules and run the rules on ADAM-6000 module. User can define
the logic rule to send out message, depending on the logic condi-
tion, to the Host defined by IP. Refer to Chapter 7 for more infor-
mation about GCL. You can choose this option to receive I/O data
message from ADAM-6000 module which is enabled GCL func-
tion.
Setup Menu:
1.
Favorite Group - You can configure your favorite group including
add one new device, modify or delete one current device, sort cur-
rent devices and diagnose connection to one device.
2. Refresh COM and LAN node - ADAM.NET utility will refresh the
serial and LAN network connection situation.
3. Add COM Port Tree Nodes - This option is used to add serial COM
ports in ADAM.NET Utility. You won't need to use this option for
ADAM-6000 modules.
4. Show TreeView - Check this option to display the Module Tree
Display area.
Note: When you enable GCL function, Data Stream function will
automatically be disabled until you disable GLC function.