beautypg.com

2 vrrp parameters, 1 advertisement interval, 2 priority – ZyXEL Communications ZyXEL Dimension ES-4024 User Manual

Page 151: 3 preempt mode, 2 priority 23.3.2.3 preempt mode, Table 53 vrrp configuration: ip interface

background image

ES-4024A User’s Guide

150

Chapter 23 VRRP

23.3.2 VRRP Parameters

This section describes the VRRP parameters.

23.3.2.1 Advertisement Interval

The master router sends out Hello messages to let the other backup routers know that it is still
up and running. The time interval between sending the Hello messages is the advertisement
interval. By default, a Hello message is sent out every second.

If the backup routers do not receive a Hello message from the master router after this interval
expires, it is assumed that the master router is down. Then the backup router with the highest
priority becomes the master router.

Note: All routers participating in the virtual router must use the same advertisement

interval.

23.3.2.2 Priority

Configure the priority level (1 to 254) to set which backup router to take over in case the
master router goes down. The backup router with the highest priority will take over. The
priority of the VRRP router that owns the IP address(es) associated with the virtual router is
255.

23.3.2.3 Preempt Mode

If the master router is unavailable, a backup router assumes the role of the master router.
However, when another backup router with a higher priority joins the network, it will preempt
the lower priority backup router that is the master. Disable preempt mode to prevent this from
happening.

By default, a layer 3 device with the same IP address as the virtual router will become the
master router regardless of the preempt mode.

Table 53 VRRP Configuration: IP Interface

LABEL

DESCRIPTION

Index

This field displays the index number of an entry.

Network

This field displays the IP address and number of subnet mask bit of an IP domain.

Authentication Select None to disable authentication. This is the default setting.

Select Simple to use a simple password to authenticate VRRP packet exchanges on

this interface.

Key

When you select Simple in the Authentication field, enter a password key (up to eight

printable ASCII character long) in this field.

Apply

Click Apply to save the changes.

Cancel

Click Cancel to discard all changes made in this table.