Xerox ALLY PLUSTM 6287 - Manual (Page 72)

6287 ALLY PLUS User’s Manual Page 3-32
78 — Laserpage support
The AGILE 6287 ALLY PLUS supports Laserpage, a software product that
allows IBM AFP data streams to be printed to Xerox and Hewlett-Packard
laser printing systems. If using Laserpage, two-trigger pseudo transparency
must be activated (see Option #62), and this option must be enabled.
!ALLY!78=00; feature is disabled (default)
!ALLY!78=01; feature is enabled
Note: If this option is set to 01 (enabled), Option #12 — SCS right margin
and Option #22 — DSC right margin should be set to 00 (infinite line
length), Option #14 — SCS bottom margin and Option #24 — DSC bottom
margin should be set to 00 (infinite page length), and Option #70 —
DisplayWrite 370 support should be set to 00 (disabled). Otherwise,
unpredictable formatting errors could occur.
79 — Continuous program mode
This option is used by owners of the AGILE 6287 ULTRA who would like
to use ULTRA commands to configure the ALLY PLUS. This option
enables the user to send data streams with ULTRA configuration commands
embedded in them to the ALLY PLUS without changing the mode of the
ALLY PLUS. Please refer to Section 11 — 6287 ULTRA Compatibility for
more information on using ULTRA configuration commands with the
ALLY PLUS.
To configure this option:
!ALLY!79=00; feature is disabled (default)
!ALLY!79=01; feature is enabled