Xerox ALLY PLUSTM 6287 - Manual (Page 49)

Page 3-9 CONFIGURATION
• the user or the user’s application embeds escape sequences in the
data stream
• the user or the user’s application embeds transparency or pseudo
transparency strings in the data stream
• the user embeds !ALLY! commands (configuration, translate table or
PFS commands) within print jobs.
This option should not be set to infinite line length if Option #70 —
DisplayWrite 370 support is enabled. The ALLY PLUS will not buffer more
than 255 characters per line.
13 — SCS top margin
SCS SVF commands will override this setting. Refer to Section 7 for details.
After receiving an SCS form feed sequence, the ALLY PLUS will send out
line feeds until the top margin is reached. The internal margin position of
the ALLY PLUS is 01h (the default value) after a form feed has been sent.
!ALLY!13=01; printing begins on line 1 (default)
!ALLY!13=05; the ALLY PLUS will send 4 line feeds before
printing anything on the new page
14 — SCS bottom margin
SCS SVF commands will override this setting. Refer to Section 7 for details.
The bottom margin places a limit on the number of printable lines available
to the host application. This value represents the last line on which the
ALLY PLUS will allow any character to be printed before sending out a
form feed.
If the user needs the ALLY PLUS to insert form feeds, and if the desired
page length is 66 lines, this value should be set to 42h. When the ALLY
PLUS detects a printable character after 66 lines have been sent, it will first
output a form feed.
The default value is 00, which implies an infinite page length. This is the
desired setting if the application is sending form feeds and the page is a
standard size (66 lines). If the application does not send form feeds, or if the
page is a non-standard size, this option should be set to a non-zero value.