Xerox ALLY PLUSTM 6287 - Manual (Page 129)

Page 11-3 6287 ULTRA COMPATIBILITY
Note: Activating Option #79 will enable the user to configure the ALLY
PLUS on line, without changing modes and without bracketing the
configuration commands with Trigger 1 - Question Mark - Trigger 1 (¢?¢).
Configuration Options
This section lists each ULTRA configuration option and describes how the
equivalent ALLY PLUS option(s), if any, will be affected by ULTRA
configuration commands in the data stream. It also indicates how
configuration changes will be reflected in the ALLY PLUS General
Configuration Report.
1 — Column Width
Any change to ULTRA Option #1 will affect both ALLY PLUS Option #12
— SCS right margin and Option #22 — DSC right margin. The decimal
entry in the ULTRA command is executed as though it were the equivalent
ALLY PLUS hexadecimal value. The General Configuration Report will
display the decimal value.
2 — Lines Per Page
Any change to ULTRA Option #2 will affect both ALLY PLUS Option #14
— SCS bottom margin and Option #24 — DSC bottom margin. The
decimal entry in the ULTRA command is executed as though it were the
equivalent ALLY PLUS hexadecimal value. The General Configuration
Report will display the decimal value.
3 — Line Spacing
Any change to ULTRA Option #3 will affect both ALLY PLUS Option #15
— SCS line spacing and Option #25 — DSC line spacing. The user may
enter any value between 1 and 9 (executed as though it were the equivalent
ALLY PLUS value between 01 and 09, although only one digit will be
displayed in the General Configuration Report).
4 — Local Copy Null Line Suppression
This option is equivalent to ALLY PLUS Option #32. A “Y” value is
executed as though it were an ALLY PLUS value of 01, and an “N” value
is executed as an ALLY PLUS value of 00. The General Configuration
Report will display “yes” or “no.”