Xerox ALLY PLUSTM 6287 - Manual (Page 134)

6287 ALLY PLUS User’s Manual Page 11-8
30 — Pseudo Transparency Mode (PTM) Selection
This option is equivalent to ALLY PLUS Option #62. A value of “A” is
executed as though it were an ALLY PLUS value of 02, and a value of “B”
is executed as an ALLY PLUS value of 01. The General Configuration
Report will display either “0=disabled,” “1=one trigger method” or “2=two
trigger method.”
Note: Since the ULTRA does not provide the option of disabling pseudo
transparency, pseudo transparency cannot be disabled with an ULTRA
configuration command.
31 — Discard PTM Terminating Delimiter
This option is equivalent to ALLY PLUS Option #67. A value of “Y” is
executed as though it were an ALLY PLUS value of 01, and a value of “N”
is executed as an ALLY PLUS value of 00. The General Configuration
Report will display “yes” or “no.”
Note: The default value of the ULTRA is “No.” The ALLY PLUS default
value is “Yes.”
32 — DSC Trigger 1
This option is the equivalent of ALLY PLUS Option #63.
33 — DSC Trigger 2
This option is the equivalent of ALLY PLUS Option #64.
34 — SCS Trigger 1
This option is the equivalent of ALLY PLUS Option #65.
35 — SCS Trigger 2
This option is the equivalent of ALLY PLUS Option #66.
36 — Reserved
This option is reserved in the current ULTRA firmware, and it has no
equivalent in the ALLY PLUS.