71 — md-laser support, 72 — metacode support – Xerox ALLY PLUSTM 6287 User Manual

Page 69

Page 3-29

CONFIGURATION

71 — MD-Laser support

The AGILE 6287 ALLY PLUS is capable of supporting the continuous

escape mode offered in Maersk Data products. If using Maersk Data

software, enable this feature.

!ALLY!71=00;

feature is disabled (default)

!ALLY!71=01;

feature is enabled

Note: If this option is set to 01 (enabled), Option #12 SCS right margin

and Option #22 DSC right margin should be set to 00 (infinite line

length), Option #14 SCS bottom margin and Option #24 DSC bottom

margin should be set to 00 (infinite page length), and Option #70

DisplayWrite 370 support should be set to 00 (disabled). Otherwise,

unpredictable formatting errors could occur.

72 — Metacode support

Metacode is a variation of 35h transparency (see Option #60), with the

exception that this transparency mode is handled directly by the printer,

rather than by the ALLY PLUS. When this feature is enabled, it causes the

ALLY PLUS to send the 35h character and the count byte to the printer

without any translation, rather than removing them from the data stream. It

also sends the remaining bytes in the transparent group without any

translation. Enable this option if the printer uses Metacode transparency.

Use these sequences to enable or disable this feature.

!ALLY!72=00;

Metacode feature is disabled (default)