Sagem 4450E - Manual (Page 99)

SAGEM 3P@C
3P@C Installation Manual
Page 4-38 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Figure 4-51 Console interface connection
Console cable
Connect the
console interface
Connect the PC
serial port
Then start the HyperTerminal on the PC: Start → Programs → Accessories → Communications →
HyperTerminal. Install the HyperTerminal through the control panel if it has not been installed. For the
HyperTerminal installation method, please refer to the Help information in Windows.
Start the HyperTerminal. If it is started for the first time, you will be required to input a name and select an icon,
as shown in Figure 4-52.
Figure 4-52 Input the connection name and select an icon for it
Click to select the serial port to be connected. Note that the serial port selected must be consistent with
the one used by your PC.