Sagem 4450E - Manual (Page 113)

SAGEM 3P@C
3P@C Installation Manual
Page 6-6 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
6.3.4. 6.3.4. 6.3.4. 6.3.4. Command Line Edit Feature
Table 6-4 lists the line editing commands that can be used in the command line.
Table 6-4 Line edit commands in the command line
Command Function
Back Space or Del or
Ctrl+h Deletes a character to the left
Up arrow key, or Ctrl+p Invokes the previous history command
Left arrow key or Ctrl+b Moves the cursor to the left by a character
Right arrow key or Ctrl+f Moves the cursor to the right by a character
Down arrow key or Ctrl+n Shows the next history command if the up arrow
key has been used previously to invoke the
previous history command
Ctrl+a Moves the cursor to the beginning of the line
Ctrl+e Moves the cursor to the end of the line
Ctrl+d Deletes the character where the cursor is
Ctrl+k Deletes all characters after the cursor
Ctrl+t Changes the character where the cursor is with
that on the left of the cursor, and moves the
cursor to the right by a character
Ctrl+u Deletes the whole line
Ctrl+w Deletes all characters on the left of the cursor
prompt
Of the above commands, Del, up arrow key, down arrow
key, left arrow key and right arrow key only support the
mode of using Telnet to configure the switch, rather than
serial interface configuration. However, the Ctrl+h, Ctrl+p,
Ctrl+b, Ctrl+f and Ctrl+n commands all support the above
two login modes.
prompt
For details of the commands, see the 3P@C 4450E IP-
DSLAM Software Configuration Manual.
6.4. 6.4. 6.4. 6.4. System Management
6.4.1. 6.4.1. 6.4.1. 6.4.1. Storage Media and File Type
The 3P@COS, configuration file and other applications of 3P@C 4450E are saved in the Flash. See Table 6-5
for the related file types.
Table 6-5 Correspondence between file types and command line parameters of 3P@C
4450E
Parameter Description
3P@COS 3P@COS operating system
config-file Configuration file
adufpga|vdubfpga FPGA code of ADU and VDU