Sagem 4450E - Manual (Page 60)

SAGEM 3P@C
3P@C Installation Manual
Page 3-13 Reproduction and communication in any form prohibited without the written
permission of SAGEM SA
To unpack the packing box of the cabinet, take the following steps:
Step 1 Open the upper cover. Place the packing box as indicated and use a
claw hammer or screwdriver to remove the plastic clips around the
top cover. The cabinet is exposed.
prompt
Since the cabinet is rather heavy, three to four persons are
needed to cooperate with one another in the unpacking
process.
Step 2 Erect the packing box and pull out the two cabinet feet. Erect the
packing box to its normal position. Hold the packing box and
carefully drag outward the cabinet from the side where the cover is
removed, until the two cabinet feet are dragged out of the packing
box. Remove the foam pads under the cabinet feet and place the
cabinet feet on the floor.
Step 3 Slightly lean the packing box along with the cabinet towards the side
where the cover is removed, and use the supports of the two cabinet
feet on the floor to draw back the packing box from the reverse
direction, as shown in Figure 3-5.
prompt
Since the equipment is rather heavy, please operate it
carefully. Raise and hold rigid places such as the rack base
and skeleton to avoid damaging the equipment or any other
accidents.
Figure 3-5 Draw out the packing box backward from the reverse direction