Sagem 4450E - Manual (Page 156)

SAGEM 3P@C
3P@C Installation Manual
Page 11-3 Reproduction and communication in any form prohibited without the written permission of
SAGEM SA
Figure 11-1 Schematic diagram of pulled handle operation
Alarm indicator
Screw
Press inward
Step 5 Pull the fan module outward 10 cm by pulling the pulled handle with
your right hand, and make the fan module leave the power supply
socket of the interior sub-rack.
Step 6 If you dismount the fan module without cutting off the power supply, you
must wait for a minute before the fan stops running completely.
Step 7 Hold the pulled handle of the fan module with your right hand, and pull
the fan module out of the sub-rack completely by supporting the bottom
of the fan module with your left hand.
Step 8 Put the dismounted fan module in a safe place.
Warning
When the fan shelf is dismounted, the fan may still run. Do
not contact the fan vane. You should dismount the fan shelf
only when the fan vane stops running completely.
1.1.1.56 Install a new fan shelf
Warning
If the fan module is replaced on site without cutting off the
power supply, you should install the new fan module as soon
as possible when the original one is dismounted. The new
fan module should be prepared in advance and put in the
safe place of the installation site.
Step 1
Installing the fan support: Use screws to attach the rack-mounting ears
on both sides of the fan support to the cabinet, as shown in the figure
below: