Sagem 4450E - Manual (Page 122)

SAGEM 3P@C
3P@C Installation Manual
Page 7-7 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
a - Download system image to Flash
A - Download system image and boot
s - Download system base config information
fa - Download ADU fpga code
fv - Download VDU fpga code
da - Download ADU chip code
dv - Download VDU chip code
load - Download file to Flash
del - Delete a file in Flash
rename - Rename a file in Flash
erase fileinfo - Erase files in Flash, all files will be lost!
show flash - Show Flash file info
x - Quit
For the description of menu options, see Figure 7-2.
Step 4: Modify the download mode as Xmodem
Enter a command n, you can select either Xmodem or FTP mode. Here, select Xmodem.
Step 5: Enable the corresponding function option to download the software
Enter a command a , and the system prompts:
Downloading, please wait...
Please set console baud rate 115200
prompt
When you user the 3P@C 4450EV2.00 hardware, the system
will prompt you to modify the baud rate as 115,200. In the case
of the 3P@C 4450EV2.00 hardware, the baud rate needs to be
set to 9,600 when you connect 3P@C 4450E through the serial
port. Then, you need to disconnect 3P@C 4450E first, modify
the baud rate, and connect 3P@C 4450E again.
The system is waiting for the terminal to send files through the Xmodem protocol. Click [Send/Send files] to
initiate the function of sending files, and select the [Xmodem] protocol. Click to choose the path of the
main file, and click . The terminal begins to send files, as shown in the figure below: