Sagem 4450E - Manual (Page 178)

SAGEM 3P@C
3P@C Installation Manual
Page 12-21 Reproduction and communication in any form prohibited without the written permission of
SAGEM SA
Figure 12-7 Connection of splitters
External line
Splitter
Fax machine
Telephone
Extension
Computer
Note
Some Modems are in-built with splitters, and the connection of the
ports can be done as shown in the figure above.
2) Connection, configuration and commissioning of Modems
Confirm the normality of lines and the proper installation of central office terminals, and the Line cables and
POTS cables having been connected to the distribution frame. Try to make a call for its normal use, if it cannot
be made or gets line crossed, the wires may be correctly bonded, and should be done again; if the call can be
normally made, the next is to connect, configure and commission the Modem. Take the Modem of the in-built
splitter for example, the method is described as follows:
„ Connect the Modem with the telephone wire, and connect the network cable to the network
adapter of PC.
„ Complete the related network configuration and subscriber authentication setting.
„ Power on the Modem and wait for over ten seconds, and the SYNC indicator of the Modem is
on, showing that the VDSL link has been established.
„ Try to access the Internet, if it is possible, it shows the commissioning of VDSL.
Recording the User Information and Relevant Data
For the convenience of the later operation maintenance, the user information and the data for the initially
commissioned line connection. For details, see Table 12-9 and 12-13: