Sagem 4450E - Manual (Page 61)

SAGEM 3P@C
3P@C Installation Manual
Page 3-14 Reproduction and communication in any form prohibited without the written
permission of SAGEM SA
Step 4 Remove the packing materials of the cabinet such as the
plastic bag.
Step 5 Take out the marking template and the guide rails inside the
cabinet.
3.5.3. 3.5.3. 3.5.3. 3.5.3. Goods Acceptance
After unpacking, inspect and accept the goods against the contract and the packing list as follows:
„ Appearance check: Check if the outer appearance of the equipment has any
defect, looseness or damage, and if the identifying words are legible, and if the
chassis boards and decorating plates are all installed and meet the requirements
for use.
„ Integrity check: Check if all the components and accessories needed for
installation of the equipment are complete and matched.
„ The engineering staff (engineers or representatives) of SAGEM sa should take
the main responsibility for checking electrically sensitive devices and
components.
„ Lay out the inspected goods according to their different types. Keep the
unpacked packing box at least till the user signs on the packing list.
The following basic assemblies are contained inside the packing box of 3P@C 4450E:
„ One set of 3P@C 4450E equipment (including a 10U chassis and the
backplane)
„ One fan module and one fan mounting support
„ One air deflector frame
„ One suite of installation accessories (including engineering labels, cable ties and
screws)
„ Suite of subscriber cables
„
DC power cable
„ One RS-232C console cable
„ One User Manual
„ User registration/warranty card
prompt
The assemblies of the actual purchased equipment and the
specific quantities of the components/accessories shall
depend on the onsite packing list or the purchase contract of
the purchased equipment.
If there is any product damaged or even lost in the box, contact the distributor or the most available
salesmen of SAGEM sa. Also please keep away all the packing materials for future packing of the
switch.