Sagem 4450E - Manual (Page 85)

SAGEM 3P@C
3P@C Installation Manual
Page 4-24 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
To install the uplink interface module, take the following steps:
Step 1 Place the SMUB on a flat and stable insulating desktop, and
remove the baffle plate in the position of the uplink interface.
Step 2 Take out the purchased uplink interface module from the packing
box, fix two fixation copper bars and an interface board panel to
the interface module with screws, insert the uplink interface of the
uplink interface module into the uplink interface of the SMUB,
align the pins of the interface module with the SMUB socket, and
then push the pins into the socket with even force, as shown in
Figure 4-31. Now the screw holes on the four corners of the
interface board are aligned with the four screw holes on the
SMUB. Get ready to install the screws.
Figure 4-31 Insert the pins of the uplink interface module into the socket of the SMUB
Rear side of the uplink
interface module
Connection socket
Connect the uplink interface of
the uplink interface module first
SMUB
Then align the pins of the uplink
interface module with the SMUB socket
and parallelly press them into the socket
Note
You should hold the edges of the module instead of
touching the component or the printed circuits to avoid
damage to the component caused by human static
electricity.
Step 3 Fix the module with the special-purpose screws used to install
the uplink interface module, as shown in Figure 4-32.