Sagem 4450E - Manual (Page 77)

SAGEM 3P@C
3P@C Installation Manual
Page 4-16 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Figure 4-21 Fixing the hangers onto the 10U chassis
Hanger
Side view of the
installation
Step 2 Hold the two edges of the 10U chassis and slowly slide it inward
from the front face of the rack, till the hangers bit the rack.
Step 3 Align the screw holes on the front face of the hangers with the
screws on the rack and fasten them with screws to ensure the
stability of the equipment, as shown in Figure 4-22.
Figure 4-22 Insert the 10U chassis into the rack and fix it
4.2.2. 4.2.2. 4.2.2. 4.2.2. Installing the Fan Module
The fan module should be installed below the 10U chassis in the following steps:
Step 1 Install the fan support and connect the hangers at the two
sides of the fan support with screws, as shown in the following
figure.