Sagem 4450E - Manual (Page 148)

SAGEM 3P@C
3P@C Installation Manual
Page 9-7 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Indicator Flag Color Status Description
Flashing Data is being
received/transmitted in the
user interface. ACT Green
Off No data is
received/transmitted in the
user interface.
Table 1-5 Description of the indicator of the ADUB service board
Indicator Flag Color Status Description
On Power on the system.
Off No power on or the system runs
abnormally.
RUN Green
Flashing The ADUB runs normally.
Off The ADUB runs normally.
Status indicator
of the ADUB
ALM Red
ON The ADUB has an alarm.
Table 1-6 Description of the indicator of the ADUC service board
Indicator Flag Color Status Description
On Power on the system.
Off No power on or the system runs
abnormally.
RUN Green
Flashing The ADUC runs normally.
Off The ADUC runs normally.
Status indicator
of the ADUC
ALM Red
ON The ADUC has an alarm.
9.2.2. Hot Plugging
The device supports the hot plugging of the service board in the normal running, and the original configuration
information is saved in the system in the plugging process. Two situations happen when the user replaces the
service board:
„ If the type of the subsequently plugged card is the same as that of the unplugged card, the
original configuration information will be recovered automatically.
„ If the type of the subsequently plugged card is different from that of the unplugged card, the
original configuration information will not be recovered automatically, and the user needs to
configure the new card.
After unplugging the card from a slot, you cannot plug the card immediately, and you should do it in a minute.
Note
During the system startup process, the hot plugging is not
supported.