Sagem 4450E - Manual (Page 55)

SAGEM 3P@C
3P@C Installation Manual
Page 3-8 Reproduction and communication in any form prohibited without the written permission of
SAGEM SA
„ One pair of scissors
„ One level bar
„ One percussion drill
„ One dust cleaner
„ Anti-static wrist strap
If the equipment is to be installed on the antistatic floor, an additional electric saw should be
prepared before the formal installation.
The following cables are needed for connection:
„ Power cables
„ Serial port console cables
„ Grounding cables
„ Network cables or fibers
Others that are needed include:
„ A computer with HyperTerminal software installed
„ The modules to be installed
3.4. 3.4. 3.4. 3.4. Product Configuration List
3.4.1. 3.4.1. 3.4.1. 3.4.1. Basic Configuration of the Product
Table 1-1 Basic configuration list of 3P@C 4450E
Item Name Quantity Description
1 3P@C 4450E-
IPDSLAM-10U general
chassis kit 1 PCS Including a 10U chassis, a
backplane, a fan module, a fan
mounting support and an air
deflector frame
2 Accessories for
installation 1 suite Including engineering labels, cable
ties, screws and RS-232C console
cables
3 DC power cable 1 PCS Cut as required
4 Grounding cable 1 PCS Cut as required
3.4.2. 3.4.2. 3.4.2. 3.4.2. Optional Components
Table 1-2 List of the optional components for 3P@C 4450E
Item Optional Component maximum
configuration Accessories
Needed
1 Service Processor Unit Board
(SMUB) 2 -----
2 VDSL Unit Board (VDUB) 14 A suite of
subscriber cables
3 ADSL Unit Board/Card (ADUB,
ADUC) 14 A suite of
subscriber cables
4 Route Transfer Unit (RTU) 1 -----
5 1-port gigabit long-wave single-mode
interface module (
DS-1GLX)
2×2 -----
6 1-port gigabit short-wave multi-mode
interface module (
DS-1GSX)
2×2 -----
7 4-port 100M electric interface module
(
DS-4TXB)
2×2 -----
8 VAS card (DS-4ITX) 2Ч2 -----