Sagem 4450E - Manual (Page 86)

SAGEM 3P@C
3P@C Installation Manual
Page 4-25 Reproduction and communication in any form prohibited without the written permission of SAGEM SA
Figure 4-32 Fix the uplink interface module with screws
Uplink interface
module
SMUB
Uplink interface
module
SMUB
By now, the uplink interface module is installed.
The method for removing the uplink interface module is similar to the installation method. Only the procedure is
reverse.
4.4.2. 4.4.2. 4.4.2. 4.4.2. Installing the RTU
Each SMUB can be installed with an optional RTU module (please refer to Section 2.6 for the selection of RTU).
The RTU does not provide any external interface. It only provides the L3 routing and flow table functions for the
SMUB. There are 4 screw holes and a connection socket on the SMUB corresponding to the installation position
of the RTU, as shown in Figure 4-33:
Figure 4-33 Installation position of the RTU
Connection
socket
Uplink
interface
module
Uplink
interface
module
Screw hole
RTU module