Siemens HIPATH 8000 OPTIPOINT410 - Manual (Page 89)

DLS Mobility Function
89
Step by Step
The logoff is shown simultaneously at the remote tele-
phone, and as soon as the logon procedure is success-
fully completed, MOB is shown on the display of your
telephone.
Logon with Delayed Forced Logoff at the
Remote Telephone
If the remote telephone is busy and the service person-
nel has set "Forced Logoff During Call" with a delay
time, the logoff at the remote telephone only takes
place after this delay time has expired.
Logging on using the key
One of the function keays was set up as logon key for
the mobility function.
Press the "Mobility" logon key. You are asked to enter
your "Mobility ID".
or Logging on using the menu
> : Select and confirm.
: Confirm to start the logon procedure.
o
Enter your Mobility ID (in general this is the same as
your official telephone number).
o Enter your User password (default value: "000000").
The following messages appear on the display:
• „Mobility logon: Validating request“
On the busy remote telephone the message "Forced
Logoff in Preparation". After the delay time set by the
service personnel the remote logoff is executed.
• "Mobility logon: Logging off elsewhere"
• "Mobility logon: Registering..."
• "Downloading user data"
The logoff is shown simultaneously at the remote tele-
phone, and as soon as the logon procedure is success-
fully completed, MOB is shown on the display of your
telephone.
Mobility
11=Mobility? >
1=Log on? >