Siemens HIPATH 8000 OPTIPOINT410 - Manual (Page 156)

Step by Step
Operating the Telephone with the optiPoint display module
156
Using Repdial Keys
If you press a selected dialing key with a stored number
(see page 121), the number appears in the Caller Box.
Press the programmed function key.
The stored number is displayed and dialed. When the
connection is established, you are in speakerphone
mode.
Repertory Dialing
With repertory dialing, you can enter dial control func-
tions at any point in the repertory dialing sequence.
HiPath 8000 automatically detects whether the digits
represent an IP address, a number, or a URL.
For information on programming a repdial key see
page 119.
Frank Miller
Control
Function
Action During Dialing
OK Any characters following this control func-
tion are sent immediately after the call has
been answered, and are sent as DTMF.
Pause Waits 3 seconds before sending any char-
acters following this control function.
Consult Establish a consultation call at this point.
Clear Clear the current call at this point.
Call Control
Mon 07/03/05 11:34AM
12345678
Calling