Siemens HIPATH 8000 OPTIPOINT410 - Manual (Page 166)

Step by Step
Operating the Telephone with the optiPoint display module
166
The display shows that the conference is set up. Other
parties cannot be added to this conference.
Ending the Conference
Changing back to single-line calls
Press the Hold symbol for one of the parties to place
this call on hold. The conference is ended. You can now:
• alternate between the parties;
• connect the other parties (Complete Transfer);
• re-enter the conference call;
• terminate the active call – you are connected to the
second party.
or End both calls using the display key
Press the End Conf. display key to terminate the con-
ference. You are disconnected from both parties.
or End both calls by hanging up
Prerequisite: "Allow Join in conference" was deactiva-
ted by the service personnel.
t
Replace the handset or press the loudspeaker key (in in
speakerphone mode). You are disconnected from both
parties.
or Connect the other parties using the display key
Prerequisite: "Allow Join in conference" was activated
by the service personnel.
Press the Join display key to connect the other parties.
or Connect the other parties by hanging up
Prerequisite: "Allow Join in conference" was activated
by the service personnel.
t Replace the handset or press the loudspeaker key (in in
speakerphone mode). The other two parties are con-
nected. You can start a new call.
Note that both active caller boxes are the same
distance from the line and that only the Hold
icon is available.