Siemens HIPATH 8000 OPTIPOINT410 - Manual (Page 62)

Operating the Telephone with the Display
62
Surviveability
If a HiPath 3000 fallback system was set up for your HiPath 8000,you will
still be able to use your telephone and the functions of the outage system
in case of e.g. a power outage.
If your telephone has no connection to the HiPath 8000, it will automatical-
ly connect to the HiPath 3000 fallback system. The message "Temporary
limited mode" is displayed.
While you are using the fallback system, the following functions are not
available:
• Call Forwarding ( page 43)
• Deflecting a Call ( page 27)
• Conferencing ( page 49)
• Voice Messages ( page 57)
• Reachability ( page 37)
• Callback ( page 36)
• Using Group Features ( page 60)
• Multiline Telephone – Introduction ( page 63)
• Call Display ( page 97)
• Transferring without Consultation ( page 32)
• Lock Phone with Forward ( page 115)
• Delay for Call Forward on No Reply ( page 99)
• HiPath 8000 Functions ( page 71)
Hot- and Warmline Function
Your service personnel can set up a hot or warm line for your or a specific
telephone.
If you pick up the receiver or press the loudspeaker key on this telephone,
the preset number is dialled
• immediately in case of a hot line;
• after a preset period of time in case of a warm line.
Examples:
• The elevator telephone is set to immediately dial the front desk’s tele-
phone number.
• The telephone next to an in-patient’s bed is set to dial the ward’s tele-
phone number after e.g. 1 minute if no other number is dialled.