Siemens HIPATH 8000 OPTIPOINT410 - Manual (Page 110)

Step by Step
Customizing the Telephone
110
Activating/deactivating callback
If the other party is busy, you can place a request for
callback. Callback is a HiPath 8000 function and has to
be programmed by the administrator. You are requested
to confirm callback if "Busy" appears on the display. The
callback function can be activated or deactivated.
Using the "Configuration" menu (see page 91).
> : Select and confirm.
:
Confirm in order to activate.
or
:
Select and confirm in order to deactivate.
Suppressing message about missed calls
If this function is activated, calls which have been
missed are indicated on the display of the telephone in
idle mode. If the function has been deactivated, new
calls which have been missed are indicated only by the
blinking of the relevant function key. This function does
not apply to an optiPoint display module which is in
use with your telephone.
> : Select and confirm.
:
Confirm in order to activate
or
:
Select and confirm in order to deactivate.
Rejecting a call during dialing
If this function is activated, any calls which you receive
while dialing will be rejected. The caller receives busy
tone.
> : Select and confirm.
:
Confirm in order to activate
or
: Select and confirm in order to deactivate.
49=Callback-busy? >
Switch on? >
Switch off? >
51=Idle missed calls? >
Switch on? >
Switch off? >
52=Busy when dialing? >
Switch on? >
Switch off? >