Sun Microsystems StorEdge 6900 Series - Manual (Page 37)

Chapter 2 General Troubleshooting Procedures 21
For Internal Use Only
Storage Automated Diagnostic
Environment Event Grid
The Storage Automated Diagnostic Environment generates component-specific event
grids that describe the severity of an Event, whether action is required, a description
of the event, and recommended action. Refer to Chapters 5 through 9 of this
troubleshooting guide for component-specific event grids.
▼ To Customize an Event Report
1. Click the Event Grid link on the the Storage Automated Diagnostic Environment
Help menu.
2. Select the criteria from the Storage Automated Diagnostic Environment event
grid, like the one shown in in TABLE 2-2 .
TABLE 2-2 Event Grid Sorting Criteria
Category Component Event Type Severity Action
• All (Default)
• Sun StorEdge A3500FC array
• Sun StorEdge A5000 array
• Agent
• Host
• Message
• Sun Switch
• Sun StorEdge T3+ array
• Tape
• Vvirtualization engine • All
(Default)
• Backplane
• Controller
• Disk
• Interface
• LUN
• Port
• Power • Agent Deinstall
• Agent Install
• Alarm
• Alternate Master +
• Alternate Master—
• Audit
• CommunicationEstablished
• CommunicationLost
• Discovery
• Heartbeat
• Insert Component
• Location Change
• Patch Info
• Quiesce End
• Quiesce Start
• Removal
• Remove Component
• State Change +(from offline
to online)
• State Change—(from online
to offline)
• Statistics
• Backup Red—
Critical
(Error)
Yellow—
Alert
(Warning)
Down—
System
Down
Y —This
event is
actionable
and is sent
to RSS/
SRS
N —This
event is
non
actionable