Telnet to affected sun storedge t3+ array, Re-enable the controller if possible (enable u), Replace the controller, if necessary – Sun Microsystems StorEdge 6900 Series User Manual
Page 135: Telnet to the affected sun storedge t3+ array, Replace the disk, if necessary, For internal use only
Chapter 8
Troubleshooting the Sun StorEdge T3+ Array Devices
119
For Internal Use Only
t3
controller
State
Change-
Red
Y
[ Info/Action ]
controller.u1ctr
in
T3 diag213
(ip=xxx.
20.67.213
)
is now Not-Available
(status-state changed
from
unknown
to
ready-disabled
)
Information: The Sun
StorEdge T3+ array
controller has been
disabled.
Recommended action:
1. Telnet to affected
Sun StorEdge T3+
array.
2. Verify the
controller state
with ‘fru stat’ and
‘sys stat’.
3. Run ‘logger -
dmprstlog’ to
capture controller
information.
4. Re-enable the
controller if
possible (enable u)
5. Replace the
controller, if
necessary.
t3
disk
StateChange-
Red
Y
[ Info/Action ]
disk.u1d5
in T3
rasd3-t3b1
(ip=xxx.
0.0.41
) is
now Not-Available
(status-state changed
from
unknown
to
fault-disabled
).
Information: The Sun
StorEdge T3+ array
has reported that a
disk has failed.
Recommended action:
1. Telnet to the
affected Sun
StorEdge T3+ array
2. Verify that the disk
state is in
fru
stat
,
fru list
,
and
vol stat
.
3. Replace the disk, if
necessary.
Category
Component
EventType
Sev
Action
Description
Information